Blog

HomeHome improvementHow to Install Plumbing Systems in a New Home

How to Install Plumbing Systems in a New Home

Plumbing tasks involves a simple strategy or rather concept of movement of water in and out. Plumbing systems normally features three major components in a new home, these are the drainage system, the water supply and also the fixture or appliance sets. In most parts of the world, only professional and licensed plumbers are allowed to carry out plumbing tasks or if you should do it yourself, it is advisable that you carry out the task under the supervision of a licensed plumber to oversee the entire project.

The standard plumbing procedures in a particular locality are normally determined by the local codes but then, for a new home’s placement of different fixture sets, the sizes of pipes that should be used in the project, and the entire pipe routing diagram greatly depends on the individual layout of a particular home. Herein you will learn how to install some home plumbing systems;

Timetable installation
Before you pour out the concrete foundation of your structure, you should first set up the sewer accommodation stubs but then, the bulk nature of the plumbing will take place at the later times. There is a rough-in phase of plumbing which needs to be done, this normally occurs in conjunction with duct installation and wiring phase. It should be done after completion of the framing stage but right before you hang the drywall. This is when you should install the major floor drains and follow up by connecting them to the stack. The rough-in drain installation of fittings should now be done for the tubs and sinks. It is also at this time you should think of installing the water supply pipes and also set right your toilet flanges.

The plumbing fixtures
The tubs/ shower units should be set well before you can start framing the walls since plumbing fixtures are normally too large to be set once the doorways and the walls of the structure have been framed. These plumbing fixtures should be covered with maybe using old rugs and blankets or the cardboard since more construction works are expected still to be done, covering protects them from attaining scratches. Follow up by connecting the sinks and after finishing laying the flooring and constructing the walls, set up the commodes.  If you need assistance, contact loodgieter Rotterdam.

Installing the water supply system
Your entire pressurized line of water supply will enter your house just below the frost line and then it splits into different lines, two in number, one of the line will be responsible for supplying the cold water and the other line gets connected to your home water heater. This is when the two lines will start supplying both the cold and hot water to your house appliances and each fixture. You will find other homes having water supply manifold supply systems that feature large panels that have in place the blue valves on one side and also the red ones on the other side. The valves are responsible for controlling individual cold or hot tube that supplies or rather directs water to a fixture. This way, everything turns to be simple when you need to shut off the water supply to a particular fixture without necessarily shutting off the whole house water supply system.

The drainage pipes
A soil stack and also the main vent that is normally in diameter four inches runs vertically right to the roof-line above right from the ground floor. All the waste drains normally connects to the stack thus providing direction of all wastes downwards all through to the sewer drain and it thereafter exits at the home just is right below ties and the frost line into the local municipal sewer system or to those connected to the personal septic systems, it will run there.

The vent pipes
Water locks can happen at the drainpipes if there is no constant air source and this might lead to clogs. There is a need for sufficient ventilation in all drains and you can consider installing a vent just behind a sink so that it serves as additional appliances and fixtures that make a connection of within ten feet of the similar or rather a common drain line. An additional vent is required for the fixtures that sit far away from a common vent.

Written by

The author didnt add any Information to his profile yet

Leave a Comment